Operator`s manual

Fig. 63 - Pan Head Screw
5. Attach the doors to the hinges on the side
panels using eight plastite screws. Tighten
with a Phillips screwdriver. (Figure 64)
Fig. 64 - Plastite Screw
Attaching Handwheel
Both Models
1. Place the handwheel on the front of the
saw. The front of the saw has a D-shaft that
fits into a D-slot in the handwheeI.
2. Attach the handwheel using a screw and ex-
ternal lockwasher. (Figures 65 & 66)
Mounting the Motor
Both Models
_lh WARNING: Plugging the saw in
during assembly can result in electrical
shock or your fingers, hand, or arm
being cut off from blade contact. Do not
plug in the saw at any time during as-
sembly. The saw should only be
plugged in when it is to be used.
1. Loosen the guard clamp screw and remove
the guard from the motor.
2. Use the arbor wrenches to remove the
blade from the saw. The arbor shaft has left-
handed threads, so you will have to turn the
nut clockwise to loosen.
3. Lock the rip lock.
4. Raise the radial arm about 2 inches and
remove the styrofoam packing blocks.
5. Clean the small pieces of styrofoam off the
saw.
6. Place the motor on the center channel of
the saw and remove the three table boards
and fence.
7. Remove the lock nut and flat washer from
the motorpivot support. (Figure 67)
\
Bevel Encoder
Motor Pivot
Support
Fig. 65 Motor
Fig. 66 - Screw and External Lockwasher
25