Operator`s manual

28. Put a lockwasher and hex nut on the bolt
and tighten using a 7/16 inch wrench or sock-
et.
29. Repeat steps 27-28 with the left spacer.
30. Move the cabinet to the location where
you will use your saw.
31. Put a hex nut on each of the leveling feet.
(Figure 56)
Fig. 56 - Hex Nut for Leveling Foot
32. Put the leveling feet through the holes in
the bottom of the side panels, at the four
corners of the shelf.
33. Put another hex nut on each of the level
ingfeet and hand-tighten until they are
agairkst the side panels.
a'k
WARNING: Saw blade can roll for-
ward toward you if the leveling feet are
not correctly adjusted. Workpiece or
saw can move unexpectedly if cabinet
rocks. Fingers, hand, or arm can be cut
off from blade contact. Adjust leveling
feet before using your saw.
34. If the leveling feet raise the front of the
saw slightly higher than the rear, and if the
cabinet does not rock, go to step 40, or
If the leveling feet do not raise the front of
the saw slightly higher than the rear, go to
step 35, or
If the cabinet rocks, go to step 35.
35. Loosen the bottom hex nut on the desired
leveling foot using a 9/16 inch wrench.
36. Loosen the top nut by hand.
37. Adjust the lower nut with the 9/16 inch
wrench until the leveling foot is at the desired
height.
38. Tighten the top nut by hand.
39. Repeat steps 35-38 for the other three
leveling feet if necessary.
40. Tighten all four bottom nuts using a 9/16
inch wrench.
41. Slide the upper support into the front sup-
port to form an inverted L-shaped unit. Four
holes in each part should line up: two holes
at the top of the "L", and one hole on each
side. (Figure 57)
o-.
, Upper Support
nt Support - Solid Surface
Fig. 57
42. Put two truss head bolts through the holes
on the sides of the "L". Put a lockwasher and
hex nut on each bolt and hand-tighten.
43. Put the L-shaped assembly into place in
the cabinet. The upper support should extend
between the front and rear skirts, and the
front support should extend between the front
skirt and the angled end of the lower support.
(Figure 58)
23