Operator`s manual

Angled End Of
J Lower Support
Bottom Side Of Shelf
Fig. 52
Right Side Panel
23. Use eight truss head bolts, lockwashers,
and hex nuts to hold the skirts in place. Hand-
tighten. (Figure 53)
24. Put a truss head bolt through the hole at
the back, right corner of the shelf. This hole
goes through the shelf and the right side
panel. (Figure 54)
Rear
Right Side Panel
20. Put bolts through the four holes along the
bottom edge of the right side panel. Put a
lockwasher and hex nut on each bolt and
tighten using a 7/16 inch wrench or socket.
(Figure 52)
Note: It is sometimes difficult to get bolts
through these four holes. You may need to
use a Phillips screwdriver to help shift the
parts into place.
21. Repeat steps 19-20 with the left side panel
and the left side of the shelf
22. Turn the cabinet right side up. Attach the
skirts to the top of the side panels, with one
on the front of the cabinet and the other on
the back. (Figure 53)
Skirt ,_ Rear
Right Side Panel
Left Side Panel
Fig. 53
Shelf Front
Skirt
Shelf
Fig. 54
Front
25. Put a lockwasher and hex nut on the bolt
and tighten using a 7/16 inch wrench or sock-
et.
26. Repeat steps 24-25 on the left side of the
shelf
27. Put a truss head bolt through the back of
the right spacer and front edge of the shelf.
(Figure 55)
1 i
i l
l l
L
I I
I I
Fig. 55
/
Side Panel
Shelf
Spacer 1
©
22