Operator`s manual

10.Find the right and left side panels. Look
carefully to find the "R" and "L" stamped in
the metal near the center of the wide edge.
These stamps are the easiest way to tell the
right side panel from the left. (Figure 49)
13. Put two truss head bolts through right side
panel and spacer, one on each side.
14. Put a lockwasher and hex nut on each
bolt and tighten using a 7/16 inch wrench or
socket.
15. Put aplastic cover over the J-shaped slot
in the side panel (Figure 50)
16. Attach two hinges to the right side panel
above the spacer, using four truss head bolts,
lockwashers, and hex nuts. Tighten with a
7/16 inch wrench. (Figure 51)
Fig. 49
11. Turn the right side panel so that the J-
shaped slot is at the bottom and facing you.
12. Put a spacer inside the right side panel as
shown. The side of the spacer with two round
holes should be opposite the J-shaped slot in
the sidepanel, and the side with one larger
hole should be on the bottom. (Figure 50)
.----- Right Side
Panel
Spacer
Two Round Holes
One Larger
Ffg. 50
Right Side Panel
-Shaped Slot
/
,4
Plastic Cover
Hinge
Fig. 51
Spacer
17. Repeat steps 11-16 with the left sidepanel.
18. Lay the shelf on the rear edge with the
bottom side toward you. The angled end of
the lower support should point up.
19. Place the right side panel on the right side
of the shelf. The spacer should be on the in-
side of the cabinet. (Figure 52)
21