Operator`s manual

surethat you attach the larger hole in each
slide bracket to the rear support. Put a lock-
washer and hex nut on each bolt and tighten
using a 7/16 wrench or socket. (Figure 41)
Slide Bracket Short
Front
Support -
Solid Surface
Fig. 41
er Hole
S L!ler
; Hole
i,l Long Tabs
\L Rear Support - Solid Surface
29. Attach the front support to the four slide
brackets using four truss head bolts. Make
sure that the solid surface of the front support
is facing front. Put a lockwasher and hex nut
on each bolt and tighten with a 7/16 inch
wrench or socket. (Figure 41)
30. Put the upper support in place between
the rear and front supports. Make sure that
the upper support is inside the surfaces of the
other two parts. (Figure 42)
Larger Ho_e
Last Two Slide Brackets
Smaller-
Hole
Upper Support
Support
Rear Support
Fig. 42
31. Put the last two slide brackets in place on
each side of the front and rear supports. Make
sure that the larger holes in the slide brackets
are in line with the rear support. (Figure 42)
32. Attach these sfide brackets using four truss
head bolts. These bolts will go through the
slide bracket, rear or front support, and the
upper support. Put a lockwasher and hex nut
on each bolt and tighten using a 7/16 inch
wrench or socket.
33. Tilt this whole assembly and slide it into
place on the cabinet. Make sure that the front
support extends between the front s/drt and
the angled end of the lower support, and that
the rear support is inside the cabinet.
(Figure 43)
Upper Support
\
Front Skirt
Left Side Panel
I
Rear Skirt
/
/
Front
Support
Angled End Of Lower Support
I
Fig. 43
"Rear Support
34. Attach the upper and front supports to the
front skirt using two truss head bolts, lock-
washers, and hex nuts. Make sure the heads
of the bolts point down as shown. (Figure 43)
35. Attach the upper support to the rear skirt
using two truss head bolts, lockavashers and
hex nuts. Make sure the heads of the bolts
point down as shown. (Figure 43)
36. Attach the front and rear supports to the
lower support using four truss head bolts, lock-
washers, and hex nuts. (Figure 43)
18