Owner's Manual

40
41
40 41
2. Set the desired bevel angle using
the bevel locking handle (1).
3. Set the desired miter angle and lock
into position. See “MITER CUT.”
SLIDE CUTTING WIDE BOARDS UP
TO 12-1/2 IN. WIDE (FIG. MM)
To avoid injury:
● Never pull the cutting head
assembly and spinning blade
toward you during the cut. The
blade may try to climb up on the
top of the workpiece, causing the
cutting assembly and spinning
blade to kick back, forcefully. The
cutting head assembly should be
drawn back completely then pushed
forward when sawing.
● Let the blade reach full speed
before cutting. This will help reduce
the risk of a thrown workpiece.
Fig. LL
1
To Slide Cut Wide Boards (Fig. MM)
1. Unlock the sliding carriage lock
knob (1) and allow the cutting head
assembly to move freely.
2. Set both the desired bevel angle
and/or the miter angle and lock into
position.
3. Use a hold-down clamp to secure
the workpiece.
4. Turn the laser guide on and position
the workpiece on the table for pre-
alignment of your cut.
5. Grasp the trigger switch handle (2)
and pull the carriage (3) forward
until the center of the saw blade is
over the front of the workpiece (4).
6. Engage the trigger to turn the
saw on.
7. When the saw reaches full speed,
slowly push the saw handle down,
cutting through the leading edge of
the workpiece.
8. Slowly move the trigger switch
handle back toward the fence,
completing the cut.
9. Release the trigger and allow the
blade to stop spinning before raising
the cutting head and removing the
workpiece.
Fig. MM
1
2
3
4
WARNING
!