Owner's Manual

30
31
30 31
EXTENSION WING USE AND
ADJUSTMENT (FIG. AA)
The left and right side extension
wings can offer extra support for long
workpieces.
1. Lift up on the locking lever (1) and
pull out the left extension wing to
the desired support length. Push
down on the locking lever (1) to
tighten the extension wing.
Repeat for the right side extension
wing if needed.
2. If the locking lever (1) will not
tighten, adjust the nut (2), located
under the base, 1/4 turn clockwise
using a 10 mm wrench until tight.
REPETITIVE CUTTING USING THE
STOP PLATE (FIG. AA)
The stop plate is designed for making
repetitive cuts of the same length.
NOTE: Use only one stop plate at a
time, NEVER use both stop plates.
1. Rotate the stop plate (3) to vertical
position.
2. If stop plate will not rotate, loosen
the locking screw (4) 1/4 turn using
a screwdriver and 8 mm wrench.
1
4
3
2
Fig. AA
Fig. Z
Anti-clockwise Clockwise
Laser beam
Pattern line