Owner's Manual

28 29
28
29
3. Carefully lower the saw head down
to align the saw blade with the
pattern line. Position the saw
blade to the left, center or right
side of the “pattern line” depending
on your preference for the laser
beam location.
4. With the saw plugged in, turn on
the laser guide. Your saw has been
preset with the laser beam to the
left side of the blade.
5. Looking at the front of the board,
if the laser beam is not parallel
to the “pattern line” please follow
the instructions listed below under
Procedure A.
6. Looking at the top of the board,
if the laser beam is not parallel
to the “pattern line” please follow
the instructions listed below under
Procedure B.
B. Adjusting the Position of the
Laser Beam (Fig. X, Y, Z)
Procedure A (Fig. X, Y)
1. Slightly turn the laser vertical
adjustment knob (1) to adjust the
vertical angle of laser beam on the
front of the board. When laser beam
angled from left to right, turn the
laser vertical adjustment knob (1)
clockwise; if the laser beam angles
right to left, turn laser vertical
adjustment knob (1) anti-clockwise
until the laser beam is parallel with
the vertical “pattern line”.
Procedure B (Fig. X, Z)
2. Slightly turn the laser horizontal
adjustment knob (2) to adjust the
horizontal angle of laser beam on
the top of the board. If the laser
beam is out of parallel from left
to right, turn the laser horizontal
adjustment knob (2) clockwise; If the
laser beam is out of parallel from
right to left, turn the laser horizontal
adjustment knob (2) anti-clockwise
until the laser beam is parallel with
the horizontal “pattern line”.
3. Recheck the laser beam alignment.
NOTE:
● Laser beam is calibrated and set up
to project to the left of the blade.
● If you have any problem or question
on the laser guide, please call the
Sears Service Center.
Fig. X
Fig. Y
Laser beam
Pattern line
Anti-clockwise Clockwise
2
1