Owner's Manual

28
29
28 29
Do not remove the lock from the ON/OFF
switch during any laser adjustments.
AVOID DIRECT EYE CONTACT (FIG. W)
● Laser radiated when laser guide
is turned on. Avoid direct eye
contact.
● Laser Warning Label:
Max. Output < 5 mW Wavelength:
630-660nm, Complies with 21 CFR
1040.10 and 1040.11. Class IIIa
Laser Product. (FIG. W)
● Laser Aperture Label: AVOID
EXPOSURE: Laser radiation is
emitted from this aperture. (Fig. W)
● NOTE: All the adjustments for the
operation of this machine have
been completed at the factory.
Due to normal wear and use,
some occasional readjustments
may be necessary.
● CAUTION: Use of controls or
adjustments or performance of
procedures other than those
specified herein may result in
hazardous radiation exposure.
● CAUTION: The use of optical
instruments with this product will
increase eye hazard.
● WARNING: Do not attempt to
repair or disassemble the laser.
If unqualified persons attempt to
repair this laser product, serious
injury may result. Any repair
required on this laser product
should be performed by an
authorized service center personnel.
LASER GUIDE ADJUSTMENT
(FIG. X, Y, Z)
NOTE: All the adjustments for the
operation of this machine have been
completed at the factory. Due to
normal wear and use, some occasional
readjustments may be necessary.
A. Checking Laser Beam Alignment
1. Set the saw to a 0° miter and 0°
bevel setting.
2. Take a board and, using a straight
edge (not included), mark a 90° line
on the top and front of the board.
This line will serve as a “pattern
line” for all laser beam alignments.
Place the board on the saw table.
Fig. W
WARNING
!
WARNING
!
Laser
Aperture
Label
Laser
Warning
Label