Product Manual

Not for
Reproduction
7
Add Engine Oil and Fuel
• Place pressure washer on a level surface.
• Refer to engine operator’s manual and follow oil and
fuel recommendations and instructions.
NOTICE Any attempt to crank or start the engine before
it has been properly filled with the recommended oil will
result in equipment failure.
• Refer to engine manual for oil and fuel fill information.
• Damage to equipment resulting from failure to follow this
instruction will void warranty.
NOTICE Check oil often during engine break–in. Refer to
engine operator’s manual for recommendations.
Lubricate O‑Rings
Lubrication of o-rings is extremely important for
installation and operation. The use of a lubricant
(petroleum or synthetic grease) during assembly helps seat
o-rings properly and provides an improved seal. It also
helps protect the o-ring from damage by abrasion, pinching
or cutting and extends the life of the o-ring.
NOTICE ALWAYS apply a small amount of lubricant on
o-rings prior to assembling the garden hose to the pump
inlet(A), high pressure hose to pump outlet (B), high
pressure hose (C), spray gun (D), and nozzle extension(E).
Lubricate all connections shown, following these instructions:
1. Inspect and clean connecting surfaces prior to
lubrication and assembly.
2. Use lubricants sparingly during assembly; a light film
is all that is required.
3. Use a small brush or cotton swab to apply grease
directly to o-rings where they are not accessible (QC
fitting, M22 fitting).
Assembly
E
D
C
A
B