Installation guide

HI button - turns fan to HIGH speed
MED button - turns fan to MEDIUM speed
LOW button - turns fan to LOW speed
button - turns fan OFF
button - turns light ON/OFF when tapped quickly.
Pressing and holding button down for more than
0.7 seconds converts it into a dimmer.
page 9
11. Wall Control Operation.
ON/OFF slider switch - turns wall control ON or OFF
HIGH button - turns fan to HIGH speed
MED button - turns fan to MEDIUM speed
LOW button - turns fan to LOW speed
OFF button - turns fan OFF
L button - turns light ON/OFF when pressed once;
dims light when pressed and held down
12. Remote Control Operation.
reverse switch
diagram 1
motor
housing
(topside)
remote control
transmitter
wall
control
It is recommended that you test fan before finalizing installation.
Restore power from circuit box and light switch (if applicable).
Locate ON/OFF slider switch on wall control and set to the ON
position. Test light and dimmer function and then test fan speeds.
Next, locate remote control. Start with the light OFF and test the
light ON/OFF function by pressing the button. Test the dimmer
function by pressing the button and holding it down for 1
second. Test fan speeds with the different fan speed buttons.
(diagram 1) If the remote control operates all of the functions of
the fan, battery has been installed correctly. If the wall and/or
remote control do (does) not operate all of the fan functions, refer
to "Troubleshooting" section to solve any issues before contacting
Customer Service.
Turn fan completely off before moving the reverse switch (located
on top of the motor housing). (diagram 1) Set reverse switch to
recirculate air depending on the season:
- LEFT position in summer (diagram 2)
- RIGHT position in winter (diagram 3)
A ceiling fan will allow you to raise your thermostat setting in
summer and lower your thermostat setting in winter without
feeling a difference in your comfort.
Important: Reverse switch must be set either completely to the LEFT
or completely to the RIGHT for fan to function. If the reverse switch is
set in the middle position (diagram 4), fan will not operate.
NOTE: If the remote control interferes with other appliances,
change code switches on the transmitter to another code. If you do
change the code, turn power off first, remove the battery cover,
and, after setting the new code, go back to the instructions in the
last paragraph of Section 10 (page 8).
13. Testing Your Fan.
diagram 2 diagram 3 diagram 4