Installation Guide

page 8
9. Light Kit Assembly. (cont.)
Install the 50 watt halogen bulb, type JD E11 (included).
Tip: Do not touch glass portion of bulb with fingers or
hands. Oil from skin can cause bulb to overheat and go out
prematurely. Use cardboard box or foam wrapping bulb
was packed with to layer around glass portion of bulb.
Locate grooves on glass shade and align with nodules
on inside of light kit fitter. Push up gently on glass
shade. Turn glass shade in a clockwise direction until it
slides into place.
IMPORTANT: When you need to replace the bulb,
please allow bulb and glass shade to cool down before
touching. Use one 50 watt max. halogen bulb, type JD
E11, to replace the bulb, keeping in mind not to touch
the bulb itself as described above (see "Tip").
glass shade
motor
housing
10. Automated Learning Process./
Activating Code.
CAUTION: The remote control transmitter can be
programmed to multiple receivers or fans. If this is
not desired, turn wall switch off to any other
programmable receiver or fan.
Remove battery cover on back side of remote
control transmitter.
Use a ballpoint pen or a small screwdriver to set
the code switches 1 through 4 for the transmitter.
Use the same number sequence used when wiring
the wall control in Section 6 (page 6).
Note: Since this fan comes with a halogen bulb,
the dimmer switch (labeled D and X) has been
pre-set to the "ON" position (D). If you do not wish
to have dimming capability, please move the
switch to the "OFF" position (X).
Install one 12-volt battery (included) in
transmitter. Re-attach battery cover on transmitter.
Restore electrical power and then set slider switch
on wall control to the ON position. Within 30
seconds of turning on the wall control, press the
fan "OFF" button ( ), located on the front of the
transmitter, for 5 seconds or until light blinks
twice. Test the light and fan functions to confirm
the learning process is complete--see Section 13.
battery
cover
12V battery
dimmer
switch
code
switches
transmitter
(back)
transmitter
(front)
bulb