Installation Guide

page 7
Loosen the screws in the 2 slotted holes in the light
kit fitter (located on the underside of the motor
housing) and remove the other screw. Twist light kit
fitter and pull down carefully on light kit fitter in
order to remove.
[Note: Molex plugs MUST be disconnected BEFORE
removing the light kit fitter from the motor
housing. Molex plugs may be disconnected by
simply pulling them apart.]
Time Saver: Washers for blade screws can be set on
each blade screw prior to installing blades.
Locate 12 blade attachment screws and washers in
hardware pack. Slide a blade through one of the
narrow, rectangular openings on motor housing,
aligning holes in blade with holes in blade arm
(located on INSIDE of the underside of the motor
housing)--refer to drawing at right. Insert 3 blade
attachment screws (along with washers) and then
tighten screws securely with a Phillips screwdriver.
Repeat procedure for each remaining blade.
Note: Tighten blade arm screws twice a year.
8. Blade Assembly.
9. Light Kit Assembly.
Re-attach molex plugs by connecting BLACK wire
from motor housing to BLACK wire from light kit
fitter and WHITE wire from motor housing to
WHITE wire from light kit fitter. Be sure that molex
connections snap together completely.
Carefully arrange wiring within the fitter plate. Align
slotted holes in the light kit fitter with loosened
screws in fitter plate--be careful not to pinch wires or
molex connections between the light kit fitter and the
fitter plate. Twist light kit fitter to lock. Re-insert
screw that was previously removed. Tighten all 3
screws to secure light kit fitter.
fitter plate
molex
connections
light kit fitter
motor
housing
blade
blade attachment
screws and washers
molex
connections