Installation Guide

BATH & VANITY FIXTURE
ASSEMBLY & INSTALLATION
INSTRUCTIONS FOR #25302
Please read carefully and save these instructions, as you may need them at a later
date.
CAUTION
Turn off the main power at the circuit breaker before installing the fixture, in order to
prevent possible shock.
GENERAL
All electrical connections must be in accordance with local and National Electrical
Code (N.E.C.) standards. If you are unfamiliar with proper electrical wiring
connections obtain the services of a qualified electrician.
Remove the fixture and the mounting package from the box and make sure that no
parts are missing by referencing the illustrations on the installation instructions.
ASSEMBLY AND INSTALLATION
1. At the center of the BACK PLATE (2) there are eight perforated slots. Knock out
the set matches your OUTLET BOX (1).
2. Screw the #8-32 FIXTURE MOUNTING SCREWS (13) into the BACK PLATE
(2) and thread the #8-32 HEX NUTS (14) onto the FIXTURE MOUNTING
SCREWS (13), as shown. Secure the position of the FIXTURE MOUNTING
SCREWS (13) by tightening the HEX NUTS (14) against the BACK PLATE (2).
3. Carefully pass the power supply (6&8) wires and the SUPPLY GROUND WIRE
(5) through the center hole of the BACK PLATE (2). Secure the BACK PLATE
(2) to the OUTLET BOX (1) with MOUNTING SCREWS (3).
4. Attach the BLACK SUPPLY WIRE (8) to the SMOOTH (or BLACK) FIXTURE
LEAD WIRE (9) by using the WIRE CONNECTOR (10). At the same manner,
attach the WHITE SUPPLY WIRE (6) to the RIBBED (or WHITE) FIXTURE
LEAD WIRE (7). Loop the FIXTURE GROUND WIRE (4) around the
GROUND SCREW (11) of the BACK PLATE (2). (Note: Be sure to provide an
extra 3” length of the FIXTURE GROUND WIRE (4) for connection to the
SUPPLY GROUND WIRE (5).) Tighten the GROUND SCREW (11). Connect
the remaining FIXTURE GROUND WIRE (4) to the SUPPLY GROUND WIRE
(5) using a WIRE CONNECTOR (10). Place wiring and connections inside the
OUTLET BOX (1).
ASSEMBLY AND INSTALLATION (Continued)
5. Place the COVER PLATE (12) onto the FIXTURE MOUNTING SCREWS (13), and
secure it into place using the DECORATIVE NUT(15) provided.
6. Slide the GLASS SHADE (19) over the SOCKET (18), secure the GLASS
SHADE(19) by tightening the SOCKET RING (20). Screw the FINIAL(16) onto the
NIPPLE(17).
7. Screw light bulbs into the sockets and make sure they do not exceed the maximum
wattage specified on the fixture’s wattage rating label, MAXIMUM 100W.
INSTALLATION IS NOW COMPLETED
1. OUTLET BOX
2. BACK PLATE
3. MOUNTING SCREW
4. FIXTURE GROUND WIRE
5. SUPPLY GROUND WIRE
6. WHITE SUPPLY WIRE
7. RIBBED (OR WHITE)
FIXTURE LEAD WIRE
8. BLACK SUPPLY WIRE
9. SMOOTH (OR BLACK)
FIXTURE LEAD WIRE
10. WIRE CONNECTOR
11. GROUND SCREW
12. COVER PLATE
13. FIXTURE MOUNTING
SCREW
14. HEX NUT
15. DECORATIVE NUT
16. FINIAL
17. NIPPLE
18. SOCKET
19. GLASS SHADE
20. SOCKET RING
2
5
4
9
7
3
1
4
1
0
6
8
1
3
1
1
1