User manual

19
Figure-32 Marking the angle of cut
BEVEL CUTS
The CX207 blade can be tilted to the left
between 0° and 45° by rotating the blade tilt
hand wheel. This feature of the saw allows
making bevel cuts.
To make bevel cuts, rotate the blade tilt
hand wheel to the desired angle, looking at
the tilt scale and lock the hand wheel by
tightening the lock at the center of the hand
wheel.
After that, proceed to make the cut in the
same manner as in “Cross Cutting”. See
page-18.
ADJUSTMENTS
MAIN TABLE TO BLADE
PARALLELISM
Your CX207 will give a better result if the
main table is parallel to the blade. If it is not
parallel, the result you will get will be poor
and low quality.
To check if the table is parallel to the blade,
use an adjustable square and measure the
distance between the miter slot on the table
and the edge of the blade (front or back) as
shown in figure-33.
Figure-33 Measuring the distance using an
adjustable square
Now, lock the square in place and mark the
blade with a marker where you made the
measurement. Rotate the blade so that the
mark is opposite to the first position (front or
back) and slide the square to check if the
blade is at the same distance with the miter
slot.
The measurement should be equal on both
sides. If the measurements are not the
same, the table needs to be adjusted
parallel to the blade.