User manual

14
TEST RUN
Once you have assembled your machine
completely, it is then time for a test run to
make sure that the machine works properly
and is ready for operation.
TO TEST RUN THE MACHINE:
1. Make sure you have read the manual
and understood all the safety
instructions given in it.
2. Remove all the tools and objects from
the machine, used during set up and
assembly.
3. Lower the blade all the way down.
4. Connect the power cord to the matched
outlet and push the ON button (green)
on the switch box.
During the test run you should make sure
that the machine operates properly when
turned ON. Check all the safety features on
the machine and make sure all the safety
features work properly.
5. Turn OFF the machine.
6. Remove the safety key on the switch to
disable the ON button.
7. Try to turn the machine ON. The
machine should not start without the
safety key.
During the test run if there is any unusual
noise coming from the machine or the
machine vibrates excessively, stop the
machine immediately and disconnect from
the power source and investigate to find out
the problem with your machine.
Before starting the table saw, make sure
that you have read and understood the
manual and you are familiar with the
functions and safety features on this
machine. Failure to do so may cause
serious personal injury.
READ THE
MANUAL