User manual

13
Insert the nuts into the rear slot on the front
left rail and align the nuts with the mounting
holes on the switch bracket. Use screws
and washer and secure the switch bracket
to the rail. See figure-20.
Figure-20 Installing the switch on the rail
Attach the push stick holder to the band
saw and secure it using a bolt and washer.
See figure-21.
Figure-21 Installing the push stick holder
Install the table insert onto the table
opening as shown in figure-22.
Figure-22 Installing table insert
CONNECTING TO A DUST
COLLECTOR
The CX207 features a 2.5” diameter dust
port to connect to a dust collector.
When connecting to a dust collector, use a
proper sized hose and make sure all the
connections are sealed tightly.
It is recommended to use a proper sized
dust collector with the CX207 to ensure
adequate dust collection.
Figure-23 Connecting to a dust collector