User manual

12
and the top part of the rails are flush with
each other and parallel to the table and
extension wings. Now, tighten all the fasters
properly.
Insert four bolts into the four larger holes on
the main table and extension wings. Place
a lock washer and a nut onto each bolt from
the inner side of the table. Thread the nut a
few turn onto the bolt and do not tighten.
See figure-16.
Figure-16 Nut and bolt to secure the front
fence rail to the table and wings
Slide the front right rail onto the bolt through
the slot on the rail and then slide the front
right rail onto the bolts. See figure-17.
Figure-17 Installing the front fence rail
Connect the left and right fence rails to
each other by sliding the two pins located
on the end of the right rail into the holes on
the left rail and tighten all the fasteners.
Attach the fence handle to the fence by
threading it into the fence and place the
fence on the front and rear rails.
Make sure the bracket at the back of the
fence is below the rear rails as shown in
figure-18.
Figure-18 Correct fence position on the rear
rail
Attach the support shaft to the sliding rail
plate with a screw (provided) and slide the
sliding rail plate into the rear slot on the
front rail. Attach the opposite end of the
support shaft to the rear rail using a knob
(provided). See figure-19.
Figure-19 Installing the support shaft