User manual

11
Inspect the mating surfaces of the
extension table and main table for any
foreign material that can cause
misalignment when assembled.
Make sure the mating surfaces of the main
table and the extension wings are clean
and attach the extension wings to the table
with the help of an assistant holding the
table. Secure it using hex bolts and
washers provided. See figure 12.
Figure-12 Installing the extension wings
Place a straight-edge on the main table and
the extension wing, and make sure they are
flat with each other.
If the mating surface of the extension wing
tilts down, use a masking tape (not
provided) along the bottom edge of the
main table to shim the extension wing up.
Figure-13 Using masking tape to shim the
extension wing up
If the mating surface of the extension wing
tilts up, use a masking tape (not provided)
along the top edge if the main table to shim
the extension wing down.
Figure-14 Using masking tape to shim the
extension wing down
When the table is reinstalled, remove the
excessive masking tape using a blade.
Install the right rear rail to the table and
right extension wing and install the left rear
rail to the table and to the left extension
wing using hex bolts, hex nuts and washers
provided. See figure-15. Do not fully tighten
the nuts and bolts at this time.
Figure-15 Installing the rear rails
Make sure the bottom of the rails are
aligned with the bottom edges of the table