User manual

10
Insert the bushing onto the front hand
wheel shaft and slide the hand wheel onto
the shaft with it is flat side aligned with the
flat side of the shaft. Thread the lock knob
onto the shaft as shown in figure-8.
Figure-8 Installing blade height hand wheel
Now, turn the hand wheel and lower the
blade all the way into the saw.
Put the a piece of cardboard on the floor
and place the table saw upside down on the
cardboard to prevent the table from being
scratched.
Place the stand upside down onto the table
saw, making sure that the CX207 model
number is facing the same direction as the
front of the table saw. See figure-9.
Figure-9 Attaching stand to the table saw
Secure the stand to the saw body using hex
bolts, washers and hex nuts provided.
Now, get the help of an assistant and turn
the saw upright with the stand and place a
level on the table.
Adjust the hex nuts on the rubber feet
shown in figure-10 and make sure the saw
is level from all four sides and tighten all the
nuts and bolts on the stand.
Figure-10 Adjusting rubber feet hex nuts
Remove the cap screw on the shaft and
slide the blade tilt hand wheel onto the shaft
with it is flat side aligned with the flat side of
the shaft. Secure it using the cap screw
removed from the shaft. See figure-11.
Figure-11 Installing blade tilt hand wheel
WARNING!
CX207 is a very heavy machine, do not
over-exert yourself. For safe moving
method use fork truck or get the help of
an assistant.