User manual

9
MOUNTING TO
WORKBENCH OR STAND
The CX600 features four mounting holes on
its base which allows to be mounted on a
stand or workbench.
To mount the machine on a stand or
workbench:
Make sure the stand or the workbench is
sturdy enough to support a weight of 113
Kg (weight of CX600).
The stand or workbench must be level so
that the machine is mounted in a stable
position.
Lift the machine using a fork truck and
place it over the stand or workbench. Make
sure the machine is centered on the
workbench.
Locate the four mounting holes on the
CX600 base and mark the holes on
workbench or stand using a center punch.
Remove the machine and drill four holes
where you marked the workbench or stand
top.
Position the machine on the stand or
workbench and align the holes on the
machine base with the holes on the stand
or workbench top.
Bolt the machine base properly on the work
bench or stand top.
ASSEMBLY
Install the four handles by threading them
onto the hand wheels as shown in figure-2.
Figure-2 Handles threaded into the hand
wheels
CONTROLS
This section provides information on the
CX600 controls.
LONGITUDINAL HAND WHEELS: These
hand wheels are used to move the work
table side to side. See figure-3.
CROSS FEED HAND WHEEL: This hand
wheel is located on the front of the machine
and is used to move the work table towards
or away from the column. See figure-3.
WARNING
CX600 is a very heavy machine, do not
over-exert yourself. Use fork truck or
other mechanical devices for safe
moving method