User manual

16
3. During operation, the chips which fall
onto the sliding surface should be cleaned
in a timely fashion. Frequent inspections
should be made to prevent chips from
falling into the position between the work
table and the slide ways.
4. After the operation every day, eliminate
all the chips and clean different parts of the
machine tool and apply machine tool oil to
prevent from rusting.
5. Make sure your work area is well
ventilated.
6. Good housekeeping practice should be
followed on a daily basis keeping your
machine clean and well lubricated.
7. Check the machine everyday before
operation for; worn or damaged cord, wire,
loose nuts and bolts and make sure all the
safety devices are working properly.
SPINDLE HEIGHT DIGITAL
READOUT
When the digital spindle height gauge
display is dim or does not show at all, the
battery will need to be replaced.
Figure-15 Digital spindle height gauge
Use a Phillips screw and turn the cap,
clockwise to open it. Replace the battery
with a new one and close the cap.
CHANGING THE FUSE
The fuse (10-Amp) is located at the back of
the switch box as shown in figure-16. Turn
the button securing the fuse counter-
clockwise to open and change the fuse.
Replace the fuse with a new one and turn
the button clockwise to secure the fuse.
Figure-16 Changing the fuse
WARNING
Do not remove the chips with your bare
hands. There is a risk of cut due to
sharp-edged chips. Never use
flammable solvents or cleaning agents
or agents that generate noxious fumes.
Protect electrical components such as
motors, switches, switch boxes, etc...,
against humidity when cleaning.