User manual

15
Make sure not to over-tighten the drawbar.
Over-tightening the drawbar makes the
collet removal difficult and damages the
drawbar and the collet threads.
Re-install the drawbar cover.
GIBS ADJUSTMENT
After a period of time, movement of the
work table and the head over the slide ways
will cause normal wear that needs to be
adjusted.
To adjust the gib screws:
Make sure the switch is in the OFF position
and the cord is disconnected from the
power source.
Locate the work table horizontal adjustment
gib screw (A) on the right side of the table
and vertical adjustment gib screw (B) on
the front side of the table as shown in
figure-13.
Figure-13 Table gib adjustment screws
Locate the head adjustment gib screws on
the column as shown in figure-14.
Figure-14 Head adjustment gib screw
Use a Phillips screw driver (provided) and
tighten the screws.
Check the work table and the mill head
movement on the slide ways using the hand
wheels.
MAINTENANCE
During the life of your machine, you will
need to practice some regular maintenance
to keep your machine in peak performance
condition.
1. Treat your machine with care, keep it
clean and grease and lubricate it regularly.
Only through good care you can be sure
that the working quality of the machine will
remain constant.
2. Lubricate all slide ways lightly before
every use. The change gears and the lead
screw must also be lightly lubricated with
lithium based grease.