User manual

14
5. If you hear any unusual noise(s) coming
from the machine or if it vibrates
excessively, shut the machine OFF
immediately and disconnect from the
power source. Investigate to determine
the problem with your machine.
6. If the machine runs smoothly, proceed
to the next step.
7. Turn the machine OFF.
8. Use the forward/reverse switch and turn
the spindle in the opposite direction for
10 minutes.
COLLET REPLACEMENT
The CX600 features an R8 spindle taper
which allows using R8 collects. Collets are
used to hold the cutting tool into the
spindle.
TO INSTALL R8 COLLETS:
Make sure the switch is in the OFF position
and the cord is disconnected from the
power source.
Remove the draw bar cap as shown in
figure-12.
Hold the flat part of the spindle with one
hand while loosening draw bar with another
hand, using proper size wrenches provided.
Figure-12 Drawbar cover and spindle taper
Loosen the draw bar fully and tap it with a
rubber mallet from the top.
Carefully clean the surface of the new
collect, cutting tool and the spindle taper
and make sure there is no debris on any
part.
Insert the collect into the spindle taper and
partially thread so that it just holds it.
Insert the cutting tool into the collet and
continue to tighten. Use a hex wrench
(provided) and tighten the collet into the
spindle taper.
WARNING
Do not make any adjustments while the
machine is running. Turn the machine
OFF and un-plug the cord from the
power source before making any
adjustments. Failure to do so may
cause serious personal injury.
WARNING
The collet with the cutting tool will fall
down on to the work table if not
supported from below the cutter.