User manual

13
Figure-10 Digital spindle height gauge
controls
CHIP GUARD
The chip guard on CX600 is one of the
main safety features of this machine. The
machine does not start until the chip guard
is in its position, guarding the spindle.
Make sure the chip guard is in its closed
position before turning the machine ON.
Figure-11 CX600 Chip guard
TEST RUN
Once you have assembled your mill/drill
completely, it is then time for a test run to
make sure that the mill/drill works properly
and is ready for operation.
Remove all the tools used for assembling
the machine and make sure all the guards
are in place.
Connect the cord to the power outlet and
turn the machine ON.
TO TEST RUN THE CX600:
1. Push the green button in, on the control
panel. It should turn the machine ON.
2. Now, push the Emergency Stop Button
in, it should turn the machine OFF.
3. Turn the machine back ON, and let the
machine run on slow speed for 10
minutes.
4. Locate the High/Low speed control knob
on the left side of the machine and turn
it to high speed. Use the variable speed
control knob and increase the spindle
speed and let the machine run for
another 10 minutes.
WARNING
Before starting the mill/drill, make sure
that you have read and understood the
manual and you are familiar with the
functions and safety features on this
machine. Failure to do so may cause
serious personal injury.
WARNING
Always wear safety glasses, hearing
protection and a respirator when
operating this machine.