User manual

10
HEAD ELEVATING HAND WHEEL: This
hand wheel is located on the top right side
of the column and it is used to adjust the
head height up or down as required. Turn
the hand wheel clockwise to move the head
up and counter-clockwise to move the head
down. See figure-3.
Figure-3 CX600 controls
ADJUSTABLE TABLE STOPS: These
stops are located on the front side of the
work table as shown in figure-4. These
stops are adjusted to stop the work table at
any position along the longitudinal axis.
TABLE LOCK LEVERS: The machine
features lock levers to secure the work
table on X and Y axis in position when
needed.
The longitudinal table lock levers are
located in the front side of the machine and
must be loosened before moving the table
using longitudinal hand wheels.
The cross feed lock levers are located on
the right side of the machine, under the
work table. These two lock levers must be
loosened before moving the table using
cross feed hand wheel. See figure-4.
Figure-4 Table stops and table locks
MILL HEAD LOCK LEVERS: Located on
the right side of the column, these two lock
levers are used to lock and unlock the mill
head. Unlock the mill head before adjusting
the mill head height using the head
elevating hand wheel and re-tighten the
lock levers once the head is at the desired
height.
Figure-5 Head and quill locks levers