Instructions / Assembly

INSTALLATION PROCEDURE / STEP 3 / STEP 4

Measure opening on bottom and cut bottom track (2) 1 1/2" shorter than opening.

- 4 -

Repeat Step 4 on the other side.

Place wall jamb down over bottom track so that the back of the jamb is between the bottom track

and the wall. Using a level to insure jamb is plumb, mark hole locations. Remove jamb and drill

holes about 1 1/2" deep at each of the marked locations.

NOTE: When drilling into ceramic, glass or stone use a 1/4" (6mm) MASONRY drill bit.

NOTE: When installing on ﬁberglass or acrylic use a 1/8" (3 mm) drill

bit and discard the wall plugs. When installing on ﬁberglass or acrylic

the side jambs may need to be ﬁled at the bottom to ﬁt the contour

of the unit.

INSTALLATION PROCEDURE STEP 5/ STEP 6

STEP 4

STEP 6

STEP 3

Run a thin bead of silicone caulk down the entire length of both bottom ledges on the bottom track.

Place the bottom track into position and press down ﬁrmly along the length of the track