Instructions / Assembly
- 3 -
INSTALLATION PROCEDURE / STEP 1 / STEP 2
1
Attach rollers to flange at top of both panels. The outer panel has an oset lip on one side of the
bottom frame. This lip is on the outside face of the panel and rollers should be mounted on the same
side as the lip. The inner panel has holes drilled on one side only of the bottom frame. The holes are
on the inside face of the panel and the rollers should be mounted on the same side as the holes.
NOTE: The slots in the top flange are used to fine tune the adjustment of the panel to make up for
walls that are slightly out of square or plumb. For best results start with all rollers centered in the slot
and then make adjustments as needed.
2
Remove screws from the end of the towel bar brackets. Assemble towel bar by putting Towel Bar
Brackets (6) on either end of the Towel Bar (5) and attaching the entire assembly to the outside face
of the outside panel using the towel bar screws. To tighten the screws, place the Towel Bar Wrench
(15) into the small hole in the side of the screw head and turn the wrench to tighten.
15