Instructions

USER GUIDE
19
• You can provide your email address with the icon, where the printer will send a message if it was unable to
resolve a jam. Please check or set your e-mail address with the @ icon.
• Calibration can be initiated by touching the icon . You can set the head temperature here. You can calibrate
the appropriate FMS with the help of the first two icons.
• A test message can be sent aer calibration so the user can check whether the e-mail function is working
correctly. In addition to the e-mail, a message will also appear in the application and on the FMS reporting.
Automatic error correction process:
• The printer enters paused status, the head goes to the pause position
• It then retracts and extrude the filament
• Point two will be aempted three times
• It will aempt to extrude 6cm of filament to determine whether extrusion will cause clogging again
• If not, then printing will resume automatically. If it is clogged, an error message will be sent (if the sensor is aktiv)
• If the user has resolved the error, you can press resume printing to continue printing immediately.