Instructions

IDEX USER MANUAL
38
7.6. Removing the nozzle
Remove the filament from the head or cut the filament at
the point closest to the extruder.
• Remove the head only aer it has completely cooled
to avoid burns.
• In the Navigation menu, lower the bed level for
convenient head access during the process.
• Turn off the printer.
• The fan assembly on the head can be removed using
the 2 screws on each side. The fan unit can then be
easily removed.
• Loosen the screw on the head at the boom of the
silicone cover, but do not unscrew it. Pull out the
heat cartridge and the temperature sensor from the
heating block.
• Loosen but do not remove the 2 screws on the le
side of the black heat sink.
• This allows the boom head to be pulled out of the
black block.
• Remove the nozzle and the heat-break with
wrenches.
• The two parts can now be cleaned comfortably with
the Cleaning Kit.
• If you need further clarification please watch this
video: hps://youtu.be/I6jRyl02kl0
7.7. Removing the hotend
Remove the filament from the head or cut the filament at
the point closest to the extruder.
• Remove the head only aer it has completely cooled
to avoid burns.
• In the Navigation menu, lower the bed level for
convenient head access during the process.
• Turn off the printer.
• The fan assembly on the head can be removed using
the 2 screws on eache side. The fan unit can then be
easily removed.
• Loosen the screw on the head at the boom of the
silicone cover, but do not unscrew it. Pull out the
heat cartridge and temperature sensor from the
Heat-block.
• Remove the long screw on the extruder and then you
can remove the hotend block.
• If you need further clarification please watch this
video: hps://youtu.be/I6jRyl02kl0