Instructions
IDEX USER MANUAL
27
Troubleshooting:
If the FW update runs into an error, please do the
following:
1. Turn off the printer
2. With a piece of filament push and hold the reset
buon (a lile hole under the Ethernet port)
3. Turn on the printer
4. Release the buon
5. Install the FW as above
Please do not interrupt the process or unplug the printer
during the firmware update.
The update process takes about 3 minutes.
Language
• Select your language from the list
(EN, DE, HU, NL, FR, ES, IT)
Personalise
You can personalise your printer. There are several
options:
• Which side would you like the head position to be at
pause?
• Would you like the machine to go to XY reference at
the print finished?
• Would you like the machine to go to XY reference at
the print terminated?
• Would you like the bed to move down when the print
finished?
• Would you like to extrude when the hotend is cold?
• Warning before homing or jogging to check the build
plate for any objects.
• Would you like the machine to check the buildplate
is present?
• Would you like the machine go to the pause position\
nif you open the door while printing?
• Would you like the machine measure print bed level\
nbefore you starting print?
• Would you like to switch to expert calibration mode?