Instructions

IDEX USER MANUAL
24
Calibration
You need to calibrate your printer regularly to ensure
that you can always print in good quality and achive
good adhesion to the build plate. There are a total of 4
calibration processes that ensure perfect print quality.
There are a few important rules to follow before
calibrating:
! Heat up the nozzle and remove the filament
from the extruder.
! Clean the plate and the nozzle tip.
! Make sure the metal plate is pushed back as
far as it will go.
To preform the calibration please follow these steps:
• Select the Seings menu on the LCD screen
and touch the Calibrate icon
• Select which calibration process you want to
perform
• Press Start
Offset calibration
The offset calibration requires manual adjustment on the
printer.
Please prepare the 2.5mm hex wrench supplied with your
printer
This process will calibrate the following parameters:
Z limit distance: Required to resume a print job.
BL-Touch - nozzle offset: Required for the assisted bed
and mesh bed leveling.
Extruder 1 and Extruder 2 X-Y offsets: Required for dual
mode prints.
Extruder Z offset: Required for dual mode prints, to en-
sure that the heads are on the same Z level.
This adjustment requires the following user interven-
tions:
• The build plate moves downwards and moves the
right head over the build plate and stops.
• Loosen the two screws on the le side of the heat-
sink through the gap between the fan grilles and
allow the nozzle to move down. If necessary, press
down the heat block with the hex wrench.
• Press the Next buon. The build plate will now press
up the loosened Extruder 2 to the proper height.
• Tighten both screws and press Next to continue
calibration.
If the alignment is as it should be, the calibration process
will continue and no further intervention is required.