SDS

In case of contact, immediately flush skin with plenty of water for at least 15 minutes while
removing contaminated clothing and shoes. Thoroughly wash (or discard) clothing and shoes
before reuse.
Skin contact
Immediately flush eyes with plenty of water for at least 15 minutes. If a contact lens is present, DO
NOT delay irrigation or attempt to remove the lens. Get medical attention if irritation develops and
persists.
Eye contact
Rinse mouth. Do not induce vomiting. Do not use mouth-to-mouth method if victim ingested the
substance. Call a POISON CENTER or doctor/physician if you feel unwell.
Ingestion
Not available.Most important
symptoms/effects, acute and
delayed
In case of ingestion, the decision of whether or not to induce vomiting should be made by the
attending physician. Certain pre-existing conditions may make workers particularly susceptible to
the effects of this chemical: asthma, allergies, impaired pulmonary function.
Indication of immediate
medical attention and special
treatment needed
If you feel unwell, seek medical advice (show the label where possible). Ensure that medical
personnel are aware of the material(s) involved, and take precautions to protect themselves. Show
this safety data sheet to the doctor in attendance. Discard any shoes or clothing items that cannot
be decontaminated.
General information
5. Fire-fighting measures
Water fog. Foam. Dry chemical powder. Carbon dioxide (CO2). Addition of water or foam to the fire
may cause frothing.
Suitable extinguishing media
Do not use a solid water stream as it may scatter and spread fire.Unsuitable extinguishing
media
Fire may produce irritating, corrosive and/or toxic gases. Development of hazardous combustion
gases or vapours possible in the event of a fire. The following may develop: Acrolein.
Specific hazards arising from
the chemical
Firefighters must use standard protective equipment including flame retardant coat, helmet with
face shield, gloves, rubber boots, and in enclosed spaces, SCBA. Firefighters should wear full
protective clothing including self contained breathing apparatus. Structural firefighters protective
clothing will only provide limited protection.
Special protective equipment
and precautions for
firefighters
In case of fire and/or explosion do not breathe fumes. Firefighters must use standard protective
equipment including flame retardant coat, helmet with face shield, gloves, rubber boots, and in
enclosed spaces, SCBA. ALWAYS stay away from tanks engulfed in flame. Fight fire from maximum
distance or use unmanned hose holders or monitor nozzles. In the event of fire, cool tanks with
water spray. By fire, toxic gases may be formed (COx, NOx). Keep run-off water out of sewers and
water sources. Dike for water control.
Fire fighting
equipment/instructions
In the event of fire and/or explosion do not breathe fumes. In the event of fire, cool tanks with
water spray. Use water spray to cool unopened containers.
Specific methods
6. Accidental release measures
Keep unnecessary personnel away. Wear appropriate protective equipment and clothing during
clean-up. Ventilate closed spaces before entering them. Do not touch or walk through spilled
material.
Personal precautions,
protective equipment and
emergency procedures
ELIMINATE all ignition sources (no smoking, flares, sparks or flames in immediate area). Dike far
ahead of spill for later disposal. Following product recovery, flush area with water.
Never return spills in original containers for re-use.
Methods and materials for
containment and cleaning up
Prevent further leakage or spillage if safe to do so. Runoff or release to sewer, waterway or ground
is forbidden.
Environmental precautions
7. Handling and storage
The product is non-combustible. If heated, irritating vapors may be formed. Do not use in areas
without adequate ventilation. Wash hands thoroughly after handling. Wash hands after handling.
Observe good industrial hygiene practices.
Precautions for safe handling
Prevent electrostatic charge build-up by using common bonding and grounding techniques. Store in
a well-ventilated place. Keep the container tightly closed and dry. Store in a closed container away
from incompatible materials. Keep out of the reach of children.
Conditions for safe storage,
including any
incompatibilities
2 / 6
Material name: Flex-a-Fill Professional Grade
6
377 Version #: 01 Issue date: 04-13-2018
SDS US