Quick Start Guide

ManualsBrandscradlepoint ManualsElectronicsAdvanced Edge Router

E300 Branch Router Quick Start Guide -

DRAFT

Introduction

This document provides a brief overview of the E300 Branch Router, discusses what's inside the box, and

provides basic setup and install instructions.

Navigation

What's in the Box

Hardware

Accessories

Required Tools

Before You Begin

Location Considerations

SIM Card for Wireless Connectivity

Installing an External Modem

Setup

Understanding LEDs

Connecting to NetCloud

Troubleshooting

Resources

Help and Support

E300 Branch Router Models

What's in the Box

• One router with built-in WiFi and embedded LTE modem

• Two or Four LTE universal modem antennas (SMA)*

• An AC/DC power adapter

• One MC400 modem door screw

• Four rubber feet for desk mounting

• Antenna Alignment instructions/Wall Mount Template

• Safety, Regulatory, and Warranty Guide

*Number of antennas vary depending on the model

Summary of content (9 pages)

PAGE 1
E300 Branch Router Quick Start GuideDRAFT Introduction This document provides a brief overview of the E300 Branch Router, discusses what's inside the box, and provides basic setup and install instructions.
PAGE 2
Hardware Hardware specifications vary by model type. Accessories To enable cellular connectivity, you will also need at least one activated 2FF-sized SIM card with an active cellular data plan. Required Tools #0 Philips-head screwdriver (for LTE modem door cover) Before You Begin Read the following before setting up the E300 Branch Router.
PAGE 3
Location Considerations To ensure the E300 operates efficiently, do the following: • Ensure the device is positioned to receive optimal signal. Avoid positioning near concrete walls, metal or reflective surfaces, or any other objects that may interfere with RF reception. • Ensure plenty of ventilation. Avoid installing the device in enclosed spaces. • Do not install the device in direct exposure to the elements. Extreme heat or cold can and will impact the router's performance.
PAGE 4
2. Insert Optional External MC400 Modem. The E300 has a slot for second, removable modem (MC400). Before the E300 can be set up, the additional modem must be installed. To install this modem, do the following: a. Insert an activated 2FF-sized SIM card into the MC400 modem, metal contacts down, notch end first. b. Remove the modem door on the E300 device. c. Slide the MC400 modem into the available modem slot, USB plug first, with the Cradlepoint logo facing up. d. Replace the MC400 modem door cover.
PAGE 5
Understanding LEDs INDICATOR BEHAVIOR POWER: The Cradlepoint E300 must be powered using an approved 54 VDC power source. • Green = Powered On. • No Light = Not receiving power. Check the power switch and the power source connection. • Amber = Attention. Open the administration pages and check the router status. (WiFi version only) VPN VPN: Indicates status of VPN connection. • Blue = Connected to an active VPN.
PAGE 6
INDICATOR BEHAVIOR SIGNAL STRENGTH: LED bars indicate the active modem’s signal strength (only for embedded and removable modems). When the embedded modem is active, the bars will be blue. When the removable modem is active, the bars will be green. When the remote (captive) modem is active, the bars will be cyan (blue-green color.) • 4 Solid Bars = Strongest signal. • 1 Blinking Bar = Weakest signal. (A blinking bar indicates half of a bar.) • 4 Blinking Bars = SIM door is not installed, modem is off.
PAGE 7
How to Troubleshoot Connection Issues Once the device connects to the Internet, it should then connect to your NetCloud Manager account and start its configuration download.
PAGE 8
Mounting screw installation on Spiderman Install Spiderman: Pre-drill holes to a wall with a drill bit, Use appropriate wall anchors to attach the wall mount
PAGE 9