Installation Guide

ManualsBrandsCradlepoint ManualsComputers & Accessories5G Adapter

W4005 Outdoor 5G Millimeter Wave

Adapter Professional Installation Guide

Introduction

This document provides a brief overview of the W4005 outdoor 5G Millimeter Wave adapter,

discusses what's inside the box, and provides basic set up and install instructions.

Disclaimer

Cradlepoint, Inc. (“Cradlepoint”) does not warrant that the hardware will work properly in all

environments or applications, and makes no warranty or representation, either implied or

expressed, with respect to the quality, performance, merchantability, or fitness for a particular

purpose of the W4005 outdoor 5G Millimeter Wave adapter even when installed in accordance

with this Professional Installation Guide.

This Professional Installation Guide is provided “AS IS,” without any warranty of any kind.

Without limiting the foregoing, to the maximum extent permitted by applicable law Cradlepoint

expressly disclaims all representations, warranties and conditions, whether express, implied,

statutory, or otherwise, with respect to this Professional Installation Guide, including without

limitation any warranty of title, non-infringement, merchantability or fitness for a particular

purpose. While Cradlepoint has made every effort to ensure this Professional Installation Guide

is accurate, Cradlepoint disclaims liability for any inaccuracies or omissions that may have

occurred and shall not be liable for any adverse results caused, in whole or in part, by the

installer’s reliance upon the instructions in this Professional Installation Guide. Information in

this Professional Installation Guide is subject to change without notice and does not represent a

commitment on the part of Cradlepoint. Cradlepoint assumes no responsibility for any

Summary of content (11 pages)

PAGE 1
W4005 Outdoor 5G Millimeter Wave Adapter Professional Installation Guide Introduction This document provides a brief overview of the W4005 outdoor 5G Millimeter Wave adapter, discusses what's inside the box, and provides basic set up and install instructions. Disclaimer Cradlepoint, Inc.
PAGE 2
inaccuracies that may be contained in this Professional Installation Guide. Cradlepoint makes no commitment to update or keep current the information in this Professional Installation Guide and reserves the right to make improvements to this Professional Installation Guide and/or to the products described in this Professional Installation Guide, at any time without notice.
PAGE 3
Navigation Use the following links to quickly navigate through this quick start guide. Introduction ............................................................................................................................................ 1 Intended Audience .................................................................................... Error! Bookmark not defined. Professional Installer Network ................................................................ Error! Bookmark not defined.
PAGE 4
W4005 Outdoor 5G Millimeter Wave Adapter Models This guide applies to the following products: CRADLEPOINT W4005-5GB MODEL: S5A107A Before You Begin Read the following before setting up your W4005 outdoor 5G Millimeter Wave adapter. Location Considerations The W4005 outdoor 5G Millimeter Wave adapter is purpose-built for exterior mounting and should be installed by a professional. The following includes considerations when identifying a location for mounting.
PAGE 5
Ethernet Cable Considerations Cradlepoint recommends shielded twisted-pair (S/FTP) Ethernet cabling and connectors (Cat6a/Cat7a) for optimal wired network performance. SIM Card Setup for Wireless Connectivity A wireless broadband data plan must be added to your Cradlepoint W4005 for wireless broadband connectivity. Network providers must provision a SIM to provide wireless broadband data plans compatible for use with the Cradlepoint W4005 outdoor 5G Millimeter Wave adapter endpoints.
PAGE 6
STEP 2: Insert an Activated 2FF-Sized SIM. 1. Unscrew and detach the modem door of the W4005. 2. Insert the SIM into the slot marked SIM1 with metal contacts up and notch in. It will click into place. • To remove, depress again. 3. Use the SIM2 slot for secondary/backup. 4. Replace the modem cover and secure with the modem door screws. STEP 3: Attach antennas. Attach the 4 outdoor, Sub 6 GHz 5G/LTE antennas (included) to the N-Type connectors marked MAIN0 and DIV0/1/2.
PAGE 7
Exterior mounting conditions and locations may vary. For basic mounting best practices, refer to the following: 1. Attach the mounting plate to the W4005 using four 50mm long, 6.33mm diameter screws. • NOTE: Do not use power tools on the adapter or mounting plate. Use hand-held screw drivers to attach screws only. 2. Attach the mounting hardware to a mounting pole or other desired surface. 3. Attach the W4005 adapter with the attached mounting plate to the mounting hardware.
PAGE 8
4. Adjust the tension of the permanently installed mounting hardware bolts to point the endpoint in the desired direction. • Ensure there is sufficient room for the LTE antennas to be added 5. Tighten the mounting hardware bolts to lock the W4005 into place. STEP 5: Connect to a power source. 1. Connect the grounding wire to the ground using the installed 8mm long, 8.5mm diameter screw. 2. Connect an Ethernet cable to the PoE 2.5G LAN1 port and plug the other end into the included 802.
PAGE 9
STEP 8: Connect to NetCloud. Activate your adapter through NetCloud Manager (NCM). Your endpoint is packaged with NetCloud services, and activation requires that you log into your NetCloud account. Refer to Getting Started with NetCloud Manager for more information. Understanding LEDs Refer to the following for information about the LED indicators on the Cradlepoint W4005 outdoor 5G Millimeter Wave adapter. INDICATOR Power BEHAVIOR The Cradlepoint W4005 must be powered using an approved 802.
PAGE 10
Blinking Blue = Wi-Fi is on, but not connected to a WAN source Ethernet LAN Status Indicates wired LAN connection information. Off = Not connected Blinking = Data passing 4G LTE Modem Status LED indicates the LTE modem status. Green = Modem has established an active WAN connection Blinking Green = connecting Yellow = modem not active Blinking Yellow = Data connection error. Log into NetCloud Manager to see alerts and troubleshoot issue.
PAGE 11
4 Solid Bars = Strongest signal. 1 Blinking Bar = Weakest signal. (A blinking bar indicates half of a bar.) OTHER Other LED Indicators The Cradlepoint Logo will light up white when connected to a NetCloud Account. Troubleshooting If the adapter takes longer than 5 minutes to connect to the Internet, you may need to log into the local UI of the endpoint to make configuration changes or start the troubleshooting process. You must be physically co-located with the endpoint in order to do this.