Installation guide

Ninety day limited hardware warranty only available in the US and Canada. Product specifications are subject to change without notice. © 2012CradlePoint, Inc.
All rights reserved. CradlePoint, WiPipe™, and the WiPipe logo are trademarks of CradlePoint, Inc. in the US and other countr ies. Other trademarks are the
property of their respective owners.
cradlepoint.com
Multi-Band Omni-Directional Antenna
Mount the Antenna
Apply a small amount of thread-locker liquid to the threads on each of the six radials and screw them into the holes at the
base of the antenna. Attach the supplied L-bracket to a sturdy vertical surface using four screws. It may also be attached to
a pole with the supplied U-bolt assembly (Figure 1). Remove the hex-nut and lock-washer from the base of the antenna,
thread the antenna cable through the large hole in the L-bracket, slip the lock washer and hex-nut over the end of the cable
and tighten against the underside of the L-bracket to hold the antenna securely (Figure 2).
Warning: Lightning protection is recommended for all installations (Not sold by CradlePoint). JefaTech offers one.
http://www.jefatech.com/category/cradlepoint .Wilson Electronics offers one compatible with this device: Wilson
Part# 859988. Take extreme care to ensure that neither you nor the antenna comes near any electric power lines.
Connect the Cable
Attach the FME male to N female adapter to the antenna cable connector FINGER TIGHT ONLY. Connect the coax
extension cable (sold separately) to the antenna cable (N male side), route the extension cable to the router location and
connect to the modem antenna connectors (SMA male side).
Technical Support
Visit knowledgebase.cradlepoint.com
Disclaimer: The information provided by CradlePoint is believed to be complete and accurate. However, no responsibility is
assumed by CradlePoint, Inc. for any business or personal losses arising from its use, or for any infringements of patents or
other rights of third parties that may result from its use.