User manual

CRADLEPOINT MBR1400 | USER MANUAL – Firmware version 4.2
© 2013 CRADLEPOINT, INC. PLEASE VISIT HTTP://KNOWLEDGEBASE.CRADLEPOINT.COM/ FOR MORE HELP AND RESOURCES PAGE 93
6.8.1 Local IP Networks
Local IP Networks displays the following information for each network:
• Network Name and IP address/Netmask (along the top bar)
• Enabled: Yes/No
• DHCP Server: Enabled/Disabled
• Schedule: Enabled/Disabled – See the
Schedule tab in the Local Network
Editor
• VRRP Failover State: Disabled,
Backup, or Master (requires hardware
version 2.0)
• Routing Mode: NAT, Standard, IP
Passthrough, Hotspot, Disabled
• Access Control: Admin Access, UPnP Gateway, LAN Isolation
• Attached Interfaces: Ethernet ports, WiFi, VLAN
Click Add to configure a new network, or select an existing network and click Edit to view configuration options.
HotSpot (Captive Portal)
When you set a network as a “Hotspot” under
Routing Mode, you will also need to:
1) Configure hotspot settings under
System Settings → Hotspot
Services. Click on Configure to link to
that page.
2) If you want a hotspot that includes
WiFi, set one of your WiFi interfaces to “Open” for its Security Mode and attach this interface to your hotspot
network. Otherwise guests will need to know the password to connect to the WiFi network even before viewing a
Terms of Service page (or other hotspot options). Also, make sure your WiFi interface is “Enabled”.