User manual

CRADLEPOINT MBR1400 | USER MANUAL – Firmware version 4.2

7.1.3 General Settings

• Enabled: Select/deselect to enable/disable.

• Force NAT: Normally the LAN Route Mode

controls the use of NAT (network address

translation). When this option is selected the

router will always perform NAT when traffic is

sent out from this device.

• Priority: This number controls failover and

failback order. The lower the number, the

higher the priority and the more use the

device will get. This number will change when

you move devices around with the priority

arrows in the WAN Interfaces list.

• Load Balance: Select to allow this device to

be available for the Load Balance pool.

• Download bandwidth: Defines the default

download bandwidth for use in Load Balance

or QoS (quality of service, or traffic shaping)

algorithms. (Range: 128 Kb/s to 1 Gb/s.)

• Upload bandwidth: Defines the default

upload bandwidth for use in Load Balance

and QoS (quality of service, or traffic shaping) algorithms. (Range: 128 Kb/s to 1 Gb/s.)

• MTU: Maximum transmission unit. This is the size of the largest protocol data unit that the device can pass.

(Range: 46 to 1500 Bytes.)

• Hostname (This only shows for certain devices.)