Specifications

Local IP Networks displays the following information for each network:
Network Name and IP address/Netmask (along the top bar)
Enabled: Yes/No
Multicast Proxy (Enabled/Disabled)
DHCP Server (Enabled/Disabled)
Schedule (Enabled/Disabled – See the Schedule tab in the Local Network Editor)
VRRP Failover State (Disabled, Backup, or Master)
IPv4 Routing Mode (NAT, Standard, IP Passthrough, Hotspot, Disabled)
IPv6 Addressing Mode (SLAAC Only, SLAAC with DHCP, Disable SLAAC and DHCP)
Access Control (Admin Access, UPnP Gateway, LAN Isolation)
Attached Interfaces (Ethernet ports, WiFi, VLAN)
Click Add to configure a new network, or select an existing network and click Edit to view configuration options.
Local Network Editor
Click Add or select a network and click Edit to open the Local Network Editor to make configure a LAN. The Local Network Editor contains the following tabs:
General Settings, IPv4 Settings, IPv6 Settings, Interfaces, Access Control, IPv4 DHCP, IPv6 Addressing, Multicast Proxy, Schedule, VRRP, STP, and Wired 802.1X.
General Settings
CradlePoint AER 2100 – Manual
07/03/2014
69