Specifications

Status
The Status section of the Administration Pages displays information about many different aspects of the router. The Status tab has the following dropdown menu items:
Client List
CP Secure Connect
Dashboard
GPS
GRE Tunnels
Hotspot Clients
Internet Connections
Routing
Statistics
System Logs
VPN Tunnels
WiPipe QoS
Client List
The Client List displays the specifications of each device connected to your router, including wireless and wired clients.
Wireless Clients
For each device using a wireless connection to your router, the following information is displayed: Hostname, IP, MAC, Connection, and Time Online.
Wired Clients
For each device using a wired connection to your router, the following information is displayed: Hostname, IP, and MAC.
Client List Fields
Hostname: The name by which each computer or device in a network is known.
IP: The “IP address,” or “Internet Protocol address,” specifies a location for each device.
MAC: This is the "MAC address", a factory-assigned identifier used to identify a specific attached computer or device.
Connection: Summary of the wireless connection. For example: 802.11n, 20 MHz, 130 Mbps, -26 dBm
802.11n: The transmission standard being used by the client. Possible values include 802.11a, 802.11b, 802.11g, and 802.11n. 802.11n is the newest and best
standard, but some older devices may not support it.
20 MHz: This is the channel width that defines the theoretical data rate (in megahertz) that the attached computer or device can send to or receive from the router.
The channel width is set in Network Settings → WiFi / Local Networks. Typically this will be 20 MHz, but 40 MHz is possible if the router is set to use two
CradlePoint AER 2100 – Manual
07/03/2014
28