Specifications

WAN Configuration Rule Editor
After clicking “Add” or “Edit,” you will see a popup with the following tabs:
Filter Criteria
General Settings
IP Overrides
IPv6 Settings
Ethernet Settings
Modem Settings
WiMAX Settings
CDMA Settings
SIM/APN/Auth Settings
Filter Criteria
If you are creating a new rule, begin by setting the Filter Criteria . Create a name for your rule and the condition for which the rule applies:
Rule Name: Create a name meaningful to you. This name is optional.
Make a selection for "When," "Condition," and "Value" to create a condition for your rule. The condition will be in the form of these examples:
When Condition Value
Port is USB Port 1
Type is not WiMAX
When:
Port – Select by the physical port on the router that you are plugging the modem into (e.g., "USB Port 2").
Manufacturer – Select by the modem manufacturer, such as Sierra Wireless.
Model – Set your rule according to the specific model of modem.
Type – Select by type of Internet source (Ethernet, LTE, Modem, Wireless as WAN, WiMAX).
Serial Number – Select 3G or LTE modem by the serial number.
CradlePoint AER 2100 – Manual
07/03/2014
107