Specifications

3.5.1 Printer Parameters
Press 9 2 FUNCT to display the following parameters or press 9 0 0 FUNCT to
print them on a previously inserted document. Changes may be made as
described above. Before proceeding, see 3.4 and select the insertion sequence
which best fits your application. Default settings are indicated in bold print.
DISPLAY
REMARKS
LINES/INCH = 5 or 6
Select 5 or 6 lines per inch vertical spacing
CHARS/INCH = 10, 12 or
17
Select 10, 12 or 17 characters per inch horizontal spacing.
PRINT = DRAFT, NORMAL
or CQ
Select faster DRAFT, NORMAL, or slower but higher
quality CQ print. DRAFT should not be used on
passbooks and may degrade DP8 print quality in the
rightmost printable column.
QUIET MODE = Y or N
Select Y for reduced noise on thin documents. Select N for
darker print on thick documents.
DOCUMENT INSERT =
TOP or BOTTOM EDGE
Select insertion to the TOP EDGE or BOTTOM EDGE of
the document.
DOCUMENT INSERT =
WITH X SEC PAUSE or
WITH A KEY
Select automatic insertion 0, 1 or 2 seconds after placing
a document in the input tray or delay insertion until A is
pressed to allow more time for aligning documents.
BEGIN PRINTING =
IMMEDIATELY or AFTER
ENTER KEY
Select to begin printing IMMEDIATELY after the document
insertion or delay printing until ENTER is pressed to verify
proper alignment.
LINE # 1 = .XXX
Select the distance, between -0.80” and 0.80”, from the
document top edge to the center of the first print line.
Select 0.25” unless needing software compatibility with
another printer.
SKEW DETECTION =
CORRECT SKEW,
DETECT SKEW, or
IGNORE
Select CORRECT SKEW to automatically align skewed
documents, DETECT SKEW to detect but not align
skewed documents, or IGNORE to disable both skew
detection and correction.
SKEW DETECTION
ALLOWED = .030, .050,
.080, .110 or .130
Select the maximum skew per 4 inches of document
width. Treatment of documents with excess skew is set by
the next parameter.
IF FORM SKEWED =
ENTER/EJECT KEYS or
AUTOMATIC EJECT
If a document has excess skew, ENTER/ EJECT KEYS
will continue printing if ENTER is pressed or eject the
document if EJECT is pressed. AUTOMATIC EJECT will
always eject a document with excess skew
NOTE: Many Printer Parameters may be host configured with the HT or other
commands. This allows for dynamic reconfiguration on a document by
document or line by line basis.
6