Specifications

3.9.3 Page Overflow
If the printer is commanded to move past the last printable line on a document it
will eject the document and display PAGE OVERFLOW INSERT NEXT PAGE.
Printing will resume when another document is inserted.
3.9.4 Carriage Fault
The carriage could not move to the left margin and is probably caused by a
jammed carriage or a bad left home sensor.
3.9.5 Clear Eject Jam
At power up or when an eject command is executed and all document sensors do
not uncover, “CLEAR EJECT JAM” will be displayed. Assure no document is
covering the sensors and the sensors are clean. Turn power off before manually
removing a jammed document. If no document is in the printer, the condition may
be cleared by pressing the ENTER key while powering the printer on. If the
condition will not clear there may be a sensor failure.
3.9.6 Narrow Document
Not an error message. When a document less than 2.4” wide is inserted and the
middle sensor does not “see” a document, NARROW DOCUMENT” is displayed
and the operator can press ENTER to proceed or EJECT to abort.
4.0 Drivers (at the time of publication, 64-bit drivers are being developed and tested)
CRADEN SUPPLIED DRIVERS ARE THE INTELLECTUAL PROPERTY OF CRADEN
PERIPHERALS CORPORATION AND ARE PROTECTED BY COPYRIGHT LAW. THEY
MAY ONLY BE USED WITH A PRINTER MANUFACTURED BEFORE APRIL 2000 IF
ALLOWED BY A LICENSE AGREEMENT BETWEEN CRADEN AND THE USER OR THE
USER'S SUPPLIER. DUPLICATION OF ANY PART OF THE DRIVERS IS ILLEGAL
UNLESS ALLOWED BY A LICENSE AGREEMENT WITH CRADEN.
4.1 First Step for Installing Craden Drivers:
Create a folder in the root directory (C:\) and label it cpcdrv. Copy into it the driver
files from the CD or downloaded from the web site here www.craden.com/dd.htm
The most up to date driver installation information is on the CD included with the
printer or in the downloadable files as driver_readme.txt
4.2 Installing Craden Drivers on WINDOWS 95 OR 98:
If the printer is connecting via a USB interface, first install the USB drivers.
1. Click START, Settings, Printers. Double click Add Printer
2. Select local unless the printer is not connected to this PC and click Next.
3. Click Have Disk.
4. In "Copy manufacturer's files from:" box, enter C:\cpcdrv\W95_W98 and click
OK.
5. Select "Craden DP8" or "Craden DP9"and click Next.
6. Select the port where the printer is connected. Click Configure Port and insure
that configuration matches the printer's 9 3 FUNCT parameters. Recommended
port settings are 38400-baud, 8 data bits, no parity, 1 stop bit, and hardware
flow control. Corresponding 9 3 FUNCT values are DTR, 38400, 8, NONE, 1,
MULT, emulation I and auto CR on feed. Click Next.
7. Select Yes if you want the Craden printer to print all Windows output. Click Next.
8. Insert a page at least 5.8" wide and 6" high in a DP8 or 8.5 x 11” in a DP9. Click
Finish to install the driver and print a test page.
10