Specifications

3.5.2 Communication Parameters
Press 9 3 FUNCT to display the following Communication Parameters or press 9 0
0 FUNCT to print them on a previously inserted document. Changes may be made
as described in 3.5. Default settings are indicated in bold.
DISPLAY
REMARKS
PROTOCOL = DTR, XON/XOF or
PARALLEL INTRF.
Select the protocol which matches your system
configuration (See 3.12.2). Select PARALLEL if
the parallel interface option is installed and skip
the next four items.
BAUD RATE = XXXX
Select 1200, 2400, 4800, 9600, 19200 or 38400
baud.
WORD LENGTH = 7 or 8
Select 7 or 8 bits/word.
PARITY = XXXX
Select EVEN, ODD or NO parity bit.
STOP BITS = 1 or 2
Select 1 or 2 stop bits.
INPUT BUFFER SINGLE LINE or
MULTIPLE LINE
Select a SINGLE LINE or a MULTIPLE LINE
buffer of 11Kbytes.
EMULATION MODE = C, I, EF4565 or
EF4600/EFP95 (UNISYS emulation
available on DP9 only)
Select C to enable commands used with previous
versions of this printer. Other selections enable
commands compatible with popular PC based
financial printers.
AUTO FEED ON CARRIAGE RETURN
= Y or N
This selection available only when EMULATION
MODE is set to a UNISYS mode.
AUTO CARRIAGE RETURN ON FEED
= Y or N
Select Y unless compatibility with software written
for another printer is needed.
DUAL PORT = Y or N
DP9 Only. Select Y unless software cannot
accept ports alternating between enabled and
disabled. If N is selected, connect to either port
but not both.
PAPER OUT = NO DOC or NEVER
Select NO DOC if the parallel interface is to
indicate paper empty whenever no document is in
the printer or NEVER if it is never to indicate
paper empty.
SELECT = DOC PRES or ALWAYS
Select DOC PRES if the parallel interface is to
indicate off-line whenever no document is in the
printer or ALWAYS to always indicate on-line
3.5.3 Override Parameters
Press 9 9 FUNCT to display the following Override Parameters. Only trained
personnel should make changes.
DISPLAY
REMARKS
LOCKED or UNLOCKED
LOCKED allows parameters to be displayed but not
changed. UNLOCKED allows all parameters to be
changed with the A key.
COVER OVERRIDE OFF or
ON
OFF requires the cabinet to be closed for printing to
occur. ON allows trained personnel to print with the
cabinet open or removed. Closing the cabinet
automatically sets the override OFF.
7