MSDS
  2
SECTION 5 – FIRE FIGHTING MEASURES
FLAMMABLE 
 Yes   No   
EXTINGUISHING 
MEDIA
Carbon Dioxide, Dry Chemical, Foam, Water Fog   
FLASHPOINT (°F) & 
METHOD 
>200F (Seta Closed Cup)   
UPPER EXPLOSIVE LIMIT 
(% BY VOLUME)
NE 
LOWER EXPLOSIVE LIMIT 
(% BY VOLUME)
NE   
AUTOIGNITION 
TEMPERTURE (°F)
NE 
UNUSUAL FIRE & EXPLOSION 
HAZARDS
None known.   
SPECIAL 
FIREFIGHTING 
PROCEDURES
Wear self-contained breathing apparatus pressure demand (NIOSH approved or equivalent) & full protective gear. Use water spray to 
cool exposed surfaces.  
SECTION 6 – ACCIDENTAL RELEASE MEASURES 
PROCEDURES
Wear proper protective equipment (Section 8). Use absorbent material or scrape up dried material & place in approved container. 
SECTION 7 – HANDLING & STORAGE 
HANDLING PROCEDURES & 
EQUIPMENT
Keep out of reach of children & pets. Do not take internally. Do not breathe vapors or inhale dusts of this product. Avoid contact w/ 
skin & eyes. Do not get on clothing. Use w/ adequate ventilation. Ensure fresh air during application & drying by opening 
windows & doors.   
STORAGE REQUIREMENTS
Close container after each use. Store containers away from excessive heat & freezing. Do not store @ temperatures above 120F. Store 
away from caustics & oxidizers.   
SECTION 8 – EXPOSURE CONTROL / PERSONAL PROTECTION 
RESPIRATORY 
In case of insufficient ventilation, wear suitable respiratory equipment. A NIOSH-approved air purifying respirator w/ organic vapor cartridge may be 
necessary under circumstances where concentrations are expected to exceed exposure limits. Prevent build-up of dust & vapors by opening windows & 
doors. Wet sanding is recommended to avoid generation of dust. If dry sanding is performed, appropriate dust respirator is suggested. 
EYEWEAR
Goggles or safety glasses w/ side shields. 
CLOTHING / 
GLOVES 
Gloves recommended for prolonged or repeated skin contact. 
HYGENIC 
PRACTICES 
Remove & wash contaminated clothing before re-use. Wash hands before breaks & @ end of workday. 
SECTION 9 – PHYSICAL AND CHEMICAL PROPERTIES 
PHYSICAL STATE
Paste 
ODOR & 
APPEARANCE 
Mild odor. White/slightly off-white  paste. 
SPECIFIC GRAVITY
Approximately 1.75 to 2.0 
VAPOR DENSITY 
(AIR=1) 
NE 
EVAPORATION RATE
NE 
BOILING RANGE (°F) 
NE 
pH
Approximately 7 to 12 
SOLUBILITY IN 
WATER 
NE 
VAPOR PRESSURE (MM 
Hg)
NE 
%/WT VOLATILE 
(TNV) 
18 to 22% 
SECTION 10 – STABILITY AND REACTIVITY 
 STABILITY
 Yes    No 
Stable under normal conditions. 
INCOMPATABILITY 
 Yes    No 
Incompatible w/ strong bases & strong oxidizing agents. 
CONDITIONS 
TO AVOID
Excessive heat & freezing. 
HAZARDOUS 
POLYMERIZATION/HAZARDOUS 
DECOMPOSITION PRODUCTS
Hazardous polymerization will not occur under normal conditions. Normal decomposition products, ie: COx, NOx. 



