User Guide

Installation
Wired defense zone
Usage
NO
COM
The siren has two wired defense zones Z0 and Z1, which can be
connected to wired detectors through a wire. When the wired
detector triggers an alarm, the siren will sound and flash.。
Please connect the siren to a wireless alarm panel first when it's
used as a wireless siren. And once the panel triggers an alarm, the
siren will sound and flash.
Pressing SOS key on the alarm panel, the siren sounds and flashes,
indicating that the paring with alarm panel is successful.
When the siren is connected with wireless detectors, it can works as
an on-site alarm panel. When the siren is armed and an alarm is
triggered, it will sound and flash.
Pressing the 【arm】 button on the remote control, a short beep is
heard from the siren means that the pairing between the remote
control and siren is successful. Or triggering the detector when the
siren is armed, if the siren sounds, means the pairing is successful.
You can use remote control to quickly away-arm, home-arm and
disarm your home, and to trigger an emergency alarm.
Pressing and hold the SET button for 5s until three long beeps is
heard，meanwhile the warning light flashes for 3 times and goes
out , indicating that all wireless accessories are deleted from the
siren, and the siren is also unbound with alarm panel.
Pressing and hold the SET button for 2s until the siren beep for one
time, and the warning light is always on indicating that the siren has
been in sniffer mode. Then press SOS on the alarm panel, when
the long beep is heard from the siren and the warning light quickly
flashes once, indicating that the pairing with panel is successful.
When the short three beeps is heard and the warning light quickly
flashes for 3 times, means the siren has been paired. If there is no
operation is made for more than 20s, the siren will automatically
exit the sniffer mode.
Note: The wired defense zone of this device only supports normally
open wired detection, and it is effective in the armed status.
Work as a wireless siren
Working as an on-site alarm panel
Deleting all wireless accessories
Pairing with alarm panel
Test
Pairing with wireless accessories
Test
How to arm, home arm, disarm or make an alarm with
remote control
Button
Arm
Home arm
Disarm
SOS
What you hear
Short beep
once
Short beep
once
Short beep
twice
Alarm sound
What you see
Warning light quickly
flashes once (and the
siren will flash once
per 1min)
Quickly flashes once
(and the siren will flash
once per 1min)
Quickly flashes
twice
Quickly flashes
continuously
What happens
The alarm sounds when
a door or window opens,
or when there’s motion
in a room.
The alarm sounds
when a door or
window opens.
The alarm won’t
sound.
1 2
Pressing and hold the SET button for 2s until the siren beep for one
time, and the warning light is always on indicating that the siren has
been in sniffer mode. Then press any key on the remote control or
the detector to be learned, when the long beep is heard from the
siren and the warning light quickly flashes once, indicating that the
pairing with siren is successful. And it will automatically exit the
learning state.
When the short three beeps is heard and the warning light quickly
flashes for 3 times, means the siren has been paired (repeat code).
If there is no operation for more than 20 seconds in the learning
state, the siren will automatically exit the sniffer mode.