Torque Wrench Kit #TLTWSAE Imperial (5/8, 11/16, 13/16, 15/16, 11/16, 15/16) Instructions for Use Français, Español, Deutsch and latest updates: www.cpsproducts.com cpsproducts.
BEFORE USE Fig. 1 • Removable Wrench End Socket Arrow Indicates Tightening Direction • Wrench Size and Arrow Must Be Same Side Pivot Point To retain wrench accuracy, DO NOT LOOSEN nuts, bolts, etc. USE ONLY FOR TIGHTENING. Apply a small amount of oil between handle and wrench body. Note: If wrench is not used for an extended time, turn handle to lowest torque setting on wrench body. Rotate handle in both directions while making a few “clicks”. This re-lubricates the wrench. INSTRUCTIONS 1. 2.
Foot/Pound Scale (5-80) Inch/Pound Scale (60-960) Fig. 2 Fig. 3 Shown is 30 ft/lbs. Center-line Torque Values Handle Edge Each mark on handle = ½ ft/lb Each mark on handle = 6 in/lb UP DOWN HANDLE Example 1: Set Wrench to 7 ft/lb a) Position wrench handle so Foot/Pound scale is visible. b) Twist handle until “0” mark aligns with Center-line and 5 Foot/Pound torque value.
Fig. 4 FOOT/Pound Settings On Wrench Body Handle Scale Setting INCH/Pound Settings On Wrench Body Accuracy 5 10 15 20 25 30 35 40 45 50 55 60 65 70 75 80 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 60 120 180 240 300 360 420 480 540 600 660 720 780 840 900 960 +/- 4% (All Settings) STORAGE 1. 2. 3. Loosen Locking Knob. Turn Knurled Handle to lowest torque setting on Body Scale. Remove Wrench End and place all components back in Storage Case. Store kit in dry location.
