Specifications

2
DC Termination Panels
Model #
Description
List
Dealer
DTP1
Single frequency DC termination panel features audio ampli cation in
both directions, dip switch selection of control currents, LED indication of
panel status and on board squelch circuit. This unit will interface to virtu-
ally any two way radio. Board only - case option available.
$125.50
$81.50
DTP2
Same features as the DTP1 with monitor function.
$150.50
$97.50
DTP3
Same features as DTP2 with two frequency selection.
$192.50
$125.00
MR100
Single frequency plus monitor enclosed DC termination panel. Plugs
directly into many Motorola mobile’s microphone jack with no modi ca-
tions. Uses +5.5mA PTT and -2.5 mA monitor. Features audio ampli ca-
tion in both directions. For Maxtrac 100, 300, Radius M10,100,120,M200,
GM300, SM50, SM120, M1225, GTX, MCS2000, and CDM series ra-
dios.
$230.75
$149.95
JM100
Same features as the MR100 for use with the E.F. Johnson Challenger or
8600 series radio. +12mA PTT and +5.5mA monitor.
$230.75
$149.95
www.cpicomm.com
Option
Description
List
Dealer
-C
Black, vinyl clad steel and aluminum enclosure for the DTP series panels
$38.50
$25.00
-4W/FD
Jumper selectable 4-wire (audio on  rst pair, control currents on second
pair) or full duplex (RX audio on one pair, TX audio and control currents
pair) or full duplex (RX audio on one pair, TX audio and control currents
on second pair) DTP and XX100 series panels
$23.00
$15.00
-TR
Allows trunking status tones to pass back to remote earpiece when using
the -10 series remote and the MR100 or JM100 panel. (Standard on DTP)
$23.00
$15.00
-80 cable
Cable to connect the DTP series to the Kenwood KCT19 connector on the
-80 series radios
$27.50
$20.00
-90 cable
Cable to connect the DTP series to the Kenwood DB25 connector on the
-90 series radios
$27.50
$20.00
-Moto
cable
Cable to connect the DTP series to Motorola mobile radios with the 16 pin
accessory connector
$27.50
$20.00
Rack/DTP
19 inch rack holds 4 DTP series panels - DTP must have case option
$75.00
$50.00
Rack/MR
19 inch single height rack holds 3 MR series panels
$75.00
$50.00
DC Termination Panels Options
Model #
Description
List
Dealer
DTC1
DC to Tone control convertor box. Terminates one or more of your existing
DC remotes and provides sequential tone control on a 600 ohm balanced
pair. Features dip switch selection of desired DC control format with up to
three functions. (F1/F2, PTT, and monitor)
$397.00
$258.00
DC to Tone Convertor