Specifications

CPI Communications, Inc. • 941 Hensley Lane • Wylie, TX 75098-4909
Phone [phone] • WATS [phone] • FAX [phone] or [phone] 9/01
MCR/MCP Series Specifications
MCP200C - Termination Panel
Power requirements 13.6 Vdc, limited to 100 mA. Power
taken from radio microphone jack.
TX Control Adjusts audio level to the radio micro-
phone input.
RX Control Adjusts audio level to phone line.
Adjustable from -20 dBm to +10 dBm.
Intercom/Test button Used for test mode on power up, then
for intercom.
Line balance Used to match the MCP200c tothe phone
line
Phone line impedance 600 ohms
Connections to phone line Two wires via modular jack. Four
wire/ Full Duplex interface optional.
Connections to radio 2 wires from adapter board to control
head, rear accessory jack plug
Dimensions & Weight 1.6" x 5.5" x 5.5", 1.5 lbs.
MCR211 Alpha
Power Requirements 12 Vdc at 300 mA (alpha = 500 mA)
Indicators Channel, Zone, PTT,
Scan and Monitor, Privacy
Controls Channel and Zone up & down,
PTT, Scan, Monitor, Intercom,Privacy,
and volume control.
Line input level -20 dBm to +10 dBm
Line output level -20 dBm to +10 dBm
Line impedance 200 K ohms on-hook / idle, 600 ohms
off-hook / active
Receive compression Less than 3 dBm change in output
for 30 dBm change in input above
thresh-hold.
Speaker output 2 watts (speaker mutes when hand-set
off-hook)
Intercom Front panel microphone and intercom
switch or handset & intercom switch
Max. no. of parallel remotes50
Connections Modular jack for phone line and desk
mic, 4 position modular jack for handset.
Dimensions, Weight 5.5" x 9" x 10", 5 lbs
Additional information on this system:
No programming software is necessay fo the remote programming. Radio
programming software is needed to change necessary parameters for use with this
system. The channel and zone's of the radio must display "ch 00" and "z00"
instead of alpha characters, so that the remotes will recognize the radio display.
Available options on this system include: MCR211A : WM - wall mount option, -
BLK - unit black in color, DTMF or multi-format encoders; MCP200C -FD full
duplex option.