Specifications

CPI Communications, Inc. • 941 Hensley Lane • Wylie, TX 75098-4909
Phone [phone] • [phone] • FAX [phone] or [phone] 11/00
MCP200 series Termination Panels The are five models of
MCP200 series termination panels. The MCP200 - for use with Maxtrac 300
series and Radius M200 series radios; the MCP200G - for use with Radius
GM300 radios; the MCP200M - for use with Radius M1225 20 ch; the
MCP200MLS - for use with Radius M1225LS radios; and the MCP200S - for
use with Radius SM120 radios. All models consists of two parts. The first is a
small adaptor board that is installed in the radio. Installation is plug-in with no
wire cutting, crimping or soldering involved. The second is the termination
panel, housed in a rugged metal enclosure. The system may use any two wire,
full duplex voice grade circuit between the radio and remote sites. Four wire
interface optional.
MCR / MCP200 Series Specifications
MCR210, MCR220, MCR250 and MCR210 alpha
Powe r Requirements 12 Vdc at 300 mA (alpha = 500 mA)
Indicators Channel, PTT, Scan and Monitor.
(Privacy on alpha)
Controls Channel up & down, PTT, Scan,
Monitor ,Interco mand volume
control. (Privacy and Select on alpha)
Line inpu t level -10 dBm to 0 dBm (-20 dBm to +10
dBm on alpha)
Line outpu t level -10 dBm to +8 dBm adj. (-20 dBm to
+10 dBm on alpha)
Line impedance 200 K ohms on-hook / idle, 600 ohms
off-hook / active
Receive compression Less than 3 dBm change in output for
30 dBm change in input above thres-
hold.
Speake r output 1.2 watts at full compression (2 watts
on alpha), speaker mutes when hand-
set off-hook.
Intercom Front panel microphone and intercom
switch or with handset & intercom
switch.
Max. no. of parallel remote s 50
Connections Modular jack for phone line and desk
mic, 4 position modular jac kfor
handset. MCR250 has terminal strip
connections for power, ground and an
external handset.
Dimensions , Weight 5.5" x 9" x 10", 5 lbs
MCP200 series - Termination Panels
Powe r requirements 13.6 Vdc, limited to 100 mA. Power
taken from radio microphone jack.
TX Control Adjusts audio level to the radio micro-
phone input.
RX Control Adjusts audio level to phone line.
Adjustable from -20 dBm to +10 dBm.
Intercom/Tes t button Used for test mode on power up, then
for intercom.
Line balance Used to match the MCP200 to phone
line.
Phone line impedance 600 ohms
Connections to phone line Two wires via modular jack. Four
wire interface optional.
Connection s to radio Supplied cable plugs into radio mic
jack and “Radio” jack on MCP200 or
MCP200G.
MCP200M, MCP200MLS and
MCP200S - Supplied cable plugs
into radio accessory connector and
"Radio" jack on termination panel.
Connectio n to microphone Modular jack on front of MCP200 or
MCP200G, allows use of Motorola
palm or desk mic.
This feature not available on
MCP200M, MCP200MLS or
MCP200S . Radio is remote
operation only.
Dimensions & Weight 1.6" x 5.5" x 5.5", 1.5 lbs.